· The end mill is a KBC Model ZX30 and the lathe is a Jet BD N. On a scale of one to ten I‘m at a 1 on skill level, just being honest here. This question is about the lathe. My primary hobby is firearm competition and for that I turn the neck thickness of the brass walls from / down to +/ · This is a reproduction, not a photocopy, of an original JET BDN 9 inch metal lathe instructions and parts manual. This manual covers stock No. We also have a JET manual for the older 9″ metal lathe as well. This manual contains information about how properly operate and lubricate this www.doorway.ru Count: 2. · I have an opportunity to buy a used jet bdn lathe. I have used the machine before and it seems to work fine. I'm wondering what I should offer as a fair price for one with out the stand. I see they are going new for $ or so, I can't afford that but I .
I have an opportunity to buy a used jet bdn lathe. I have used the machine before and it seems to work fine. I'm wondering what I should offer as a fair price for one with out the stand. I see they are going new for $ or so, I can't afford that but I don't want to low ball the guy. Operating Instructions and Parts Manual 9 x inch Belt Drive Bench Lathe Model BDW JET New Sanford Road LaVergne, Tennessee Part No. M • JET products carry a limited warranty which varies in duration based upon the product. (See chart below). Q1 The BDN was a strictly v machine. I have one I bought new and the manual states connect to v, 60 cycle power supply only. Q2 The BDN came with tapered roller bearings from the factory, so no need to retrofit. pontiac was right on in all his suggestions, especially since the lathes history is not known, except for the abuse.
Manual. LWO, 1/4-Ton Hand Chain Hoist With 15' Lift Overload Protection. Manual. LWO, 1/4-Ton Hand Chain Hoist With 20' Lift Overload Protection. Manual. S, 1/2-Ton Hand Chain Hoist With 10' Lift. The end mill is a KBC Model ZX30 and the lathe is a Jet BD N. On a scale of one to ten I‘m at a 1 on skill level, just being honest here. This question is about the lathe. My primary hobby is firearm competition and for that I turn the neck thickness of the brass walls from / down to +/ 3. This lathe is designed and intended for use by properly trained and experienced personnel only. If you are not familiar with the proper and safe operation of a lathe, do not use until proper training and knowledge have been obtained. 4. Do not use this lathe for other than its intended use. If used for other purposes, Walter Meier.
0コメント